In den Warenkorb gelegt

0,00€ 0 Produkte   Einsehen
Zur Kasse

Sparkfun


Produkte Sortieren nach: Empfehlung Popularität Titel Neueste Preis
Neu

SparkFun USB UART Serial Breakout - CY7C65213   BOB-13830

The CY7C65213 USB to UART serial breakout is designed to provide users with a means to access all available I/O pins on the IC, and to provide a 6-pin UART header that is compatible with other SparkFun breakout boards. This breakout has a microUSB connector and other support circuitry to get the IC quickly up and running.

15,50€

8 auf lager
Neu

LilyPad LED (5pcs)

This is a simple pack of five Red LilyPad LEDs that are still attached to one another, letting you snap the LEDs apart at your leisure to sew into clothing or whatever else you can dream up.

  • Red  DEV-14013

    4,75€

    2 übrig
  • Yellow  DEV-14014

    4,75€

    3 übrig

ProtoSnap - LilyPad Development Board   DEV-11262

The ProtoSnap series is a new way to prototype your project without a breadboard. Everything is wired together on a single board, which makes it easy to explore the possibilities of the components before snapping them apart and building them into your project.

69,00€

8 auf lager

Bus Pirate - v3.6a   TOL-12942

The Bus Pirate v3.6a, created by Ian Lesnet, is a troubleshooting tool that communicates between a PC and any embedded device over 1-wire, 2-wire, 3-wire, UART, I2C, SPI, and HD44780 LCD protocols - all at voltages from 0-5.5VDC. This product eliminates a ton of early prototyping effort when working with new or unknown chips.

37,50€

7 auf lager

LilyPad Coin Cell Battery Holder - Switched - 20mm   DEV-13883

Sure, your flashing, chip-tune playing T-shirt is really cool at the party… but at some point you need to turn it off. And yes, you could just pull the battery, or maybe you’ve even sewn a LilyPad slide switch in-line. Wouldn’t it be nice if there was just a switch on the battery? Well, look no further.

5,50€

14 auf lager
Neu

SparkFun 9DoF Sensor Stick   SEN-13944

The SparkFun 9DoF Sensor Stick is an easy-to-use 9 Degrees of Freedom IMU. The Sensor Stick deftly utilizes the LSM9DS1 motion-sensing system-in-a-chip. It houses a 3-axis accelerometer, 3-axis gyroscope, and 3-axis magnetometer – nine degrees of freedom (9DoF) in a single IC!

15,50€

Ausverkauft
Neu

Micro Gearmotor - Enclosure   ROB-12105

These enclosures allow you to mount your micro gearmotor to other Actobotics products easily. Once your gearmotor is inserted, you can take advantage of the 0.77” hole pattern. These enclosures have a length of 1.14”, a width of 1”, and a thickness of 0.50”.

2,50€

12 auf lager
Neu

ATmega328 with Arduino Optiboot (Uno)   DEV-10524

The name says it all on this one. An ATmega328 in DIP package, pre-loaded with the Arduino Optiboot (Uno 16MHz) Bootloader. This will allow you to use Arduino code in your custom embedded project without having to use an actual Arduino board.

8,00€

Ausverkauft
Neu

Dot/Bar Display Driver - LM3914 (Linear)   COM-12694

This is the LM3914 Dot/Bar display analog-controlled LED driver that uses an alinear output scale. With this driver all it takes is a single, analog signal to drive a string of 10+ LEDs, which can be configured into either bar mode (where all LEDs below a certain point turn on) or dot mode (with only a single LED on at a time). Hook them up properly, and you can create all sorts of nifty multi-LED displays.

4,50€

Ausverkauft
Neu

Dot/Bar Display Driver - LM3916 (VU Taper)   COM-12695

This is the LM3916 Dot/Bar display analog-controlled LED driver that uses a more logarithmic/VU scale, which makes it well-suited to audio applications like VU meters.

4,50€

Ausverkauft