In den Warenkorb gelegt

0,00€ 0 Produkte   Einsehen
Zur Kasse

Sparkfun


Produkte Sortieren nach: Empfehlung Popularität Titel Neueste Preis
Neu

Ribbon Cable - 10 wire (15ft)   CAB-10647

Ribbon cable is really helpful in situations where you need to make a lot of connections without a big mess of wires. Nothing makes a project look more finished than a nice clean wiring harness.

7,00€

8 auf lager
Neu

FTDI Cable 5V   DEV-09718

The FTDI cable is a USB to Serial (TTL level) converter which allows for a simple way to connect TTL interface devices to USB. The I/O pins of this FTDI cable are configured to operate at 5V.

21,00€

9 auf lager
Neu

Barrel Jack Adapter - USB to 5.5mm   TOL-08639

This is a simple cable that adapts from a USB port to a 5.5x2.1mm barrel connector, center positive. This cable allows the user to use a USB port on a computer, laptop, or on our cigarette power supply to provide our development boards with 5V.

3,50€

Ausverkauft

JST 2 Wire Assembly   PRT-09914

This is a simple two wire cable. Great for jumping from board to board or just about anything else. There is a 2-pin JST connector on one end, bare cable on the opposite end. It also comes with the mating connector for the JST.

2,00€

17 auf lager
Neu

Barrel Jack Power Switch - M-F (3")   COM-11705

We use barrel jacks a lot around here and sometimes we need to pop a switch into the mix.That usually means hacking up a perfectly good barrel jack extension cable, but the whole point of using the barrel jacks was so that we wouldn’t have to hack things apart… Well, we found a solution: The Barrel Jack Power Switch.

3,50€

4 übrig
Neu

Bus Pirate Cable   CAB-09556

This is an interface cable for the Bus Pirate, designed to connect to its 2x5 I/O header.

6,50€

4 übrig
Neu

Jumper Wire - JST   PRT-08670

This is a simple two wire cable. Great for jumping from board to board. 2-pin JST connector on one end, bare cable on the opposite end.

2,00€

19 auf lager
Neu

JST Jumper 3 Wire Assembly   PRT-09915

This is a simple three wire cable. Great for jumping from board to board or just about anything else. There is a 3-pin JST connector on one end, bare cable on the opposite end. It also comes with the mating connector for the JST.

3,00€

42 auf lager