Prototyping in Sparkfun

SparkFun gator:bit

The SparkFun gator:bit is an all-in-one “carrier” board for your micro:bit that provides you with a fully functional development and prototyping platform. Almost every pin on the micro:bit is broken out to pads that alligator (or crocodile, if you prefer) clips so you can get the most out of it! Weiterlesen…

  • DEV-14484
24,00€
3 übrig

SparkFun RJ45 Breakout

RJ45 connectors are the kind that are used for Ethernet jacks, but they make great general purpose connectors when you need a lot of conductors. Weiterlesen…

  • BOB-00716
1,00€
11 auf Lager

SparkFun 9DoF Sensor Stick

The SparkFun 9DoF Sensor Stick is an easy-to-use 9 Degrees of Freedom IMU. The Sensor Stick deftly utilizes the LSM9DS1 motion-sensing system-in-a-chip. It houses a 3-axis accelerometer, 3-axis gyroscope, and 3-axis magnetometer – nine degrees of freedom (9DoF) in a single IC! Weiterlesen…

  • SEN-13944
15,50€
Ausverkauft

Ribbon Cable - 10 wire (15ft)

Ribbon cable is really helpful in situations where you need to make a lot of connections without a big mess of wires. Nothing makes a project look more finished than a nice clean wiring harness. Weiterlesen…

  • CAB-10647
7,00€
1 übrig

Piezo Vibrationssensor - Groß mit Gewicht

This basic piezo sensor from Measurement Specialties is often used for flex, touch, vibration and shock measurements. A small AC and large voltage (up to +/-90V) is created when the film moves back and forth. A simple resistor should get the voltage down to ADC levels. Can also be used for impact sensing or a flexible switch. Weiterlesen…

  • SEN-09197
3,25€
3 übrig

SparkFun OpenLog

The SparkFun OpenLog is an open source data logger that works over a simple serial connection and supports microSD cards up to 64GB. Weiterlesen…

  • DEV-13712
15,50€
3 übrig