In den Warenkorb gelegt

0,00€ 0 Produkte   Einsehen
Zur Kasse

Sparkfun


Produkte Sortieren nach: Empfehlung Popularität Titel Neueste Preis
Neu

LilyPad LED (5pcs)

This is a simple pack of five Red LilyPad LEDs that are still attached to one another, letting you snap the LEDs apart at your leisure to sew into clothing or whatever else you can dream up.

  • Red  DEV-14013

    4,75€

    Ausverkauft
  • Yellow  DEV-14014

    4,75€

    Ausverkauft

ProtoSnap - LilyPad Development Board   DEV-11262

The ProtoSnap series is a new way to prototype your project without a breadboard. Everything is wired together on a single board, which makes it easy to explore the possibilities of the components before snapping them apart and building them into your project.

69,00€

8 auf lager

LilyPad Coin Cell Battery Holder - Switched - 20mm   DEV-13883

Sure, your flashing, chip-tune playing T-shirt is really cool at the party… but at some point you need to turn it off. And yes, you could just pull the battery, or maybe you’ve even sewn a LilyPad slide switch in-line. Wouldn’t it be nice if there was just a switch on the battery? Well, look no further.

5,50€

6 auf lager
Neu

SparkFun Photon Wearable Shield   DEV-13842

The SparkFun Photon Wearable Shield makes it easy to add the WiFi-enabled Photon to any wearables project. Each pin on the Photon is broken out into large sewing pins. Use conductive thread to make your next wearables projects.

7,50€

Ausverkauft
Neu

MyoWare Muscle Sensor Development Kit   KIT-13772

Using our muscles to control things is the way that most of us are accustomed to doing it. We push buttons, pull levers, move joysticks … but what if we could take the buttons, levers and joysticks out of the equation?

117,00€

4 übrig
Neu

MyoWare LED Shield   DEV-13688

The MyoWare LED Shield is designed to pair with the MyoWare Muscle Sensor. The blue 10-segment bar graph shows the magnitude of the measured signal. The more muscle activation measured, the higher up the board the lit LEDs will go.

30,00€

17 auf lager
Neu

MyoWare Power Shield   DEV-13684

The MyoWare Power Shield is designed to take two standard CR2032 coin cell batteries to power the MyoWare Muscle Sensor.

5,50€

15 auf lager
Neu

MyoWare Cable Shield   DEV-13687

The MyoWare Muscle Sensor is now designed to be wearable allowing you to attach biomedical sensor pads directly to the board itself. However, there still may be cases where you want to mount the sensor pads away from the other hardware, this is where the MyoWare Cable Shield comes in.

5,50€

10 auf lager
Neu

LilyPad Pixel Board   DEV-13264

We know you love adding color to your e-textiles, adding the LilyPad Pixel Board to your project will only make it better. The pixel board is equipped with a WS2812B which is actually an RGB LED with a WS2811 built right into the LED!

5,50€

8 auf lager
Neu

ProtoSnap - LilyPad Development Simple   DEV-11201

The ProtoSnap series is a new way to prototype your project without a breadboard. Everything is wired together on a single board, which makes it easy to explore the possibilities of the components before snapping them apart and building them into your project.

59,00€

2 übrig